Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1394 / 1488

tunnel mpls autoroute metric
Syntax
tunnel mpls [ traffic-eng ] autoroute metric { absolute | relative } metricValue
no tunnel mpls [ traffic-eng ] autoroute metric
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Specifies the tunnel metric. The value determines tunnel preference when there is
more than one tunnel or native IP path to a tunnel endpoint. A lower value is preferred
to a higher value. When you set up multiple tunnels, if the primary tunnel goes down,
the existing tunnel with the lowest metric is used immediately. If you specify an
absolute value from 1–2147483647, this value overrides the metric for the path
provided by the IGP. If you specify a relative value from –10 to +10, this value is
subtracted from (–) or added to (+) the metric for the path provided by the IGP. The
no version restores the default value, relative 0, meaning that the tunnel metric is
the IGP value.
Options
■
traffic-eng—Specifies optional keyword for compatibility with non–E Series
implementations
■
absolute—Specifies that the metric is an absolute value
■
relative—Specifies that the metric is a signed relative value
■
metricValue —Preference value for a path; absolute values are in the range
1–2147483647; relative values are in the range –10–+10
Mode
Interface Configuration, Tunnel Profile Configuration
1352 ■
tunnel mpls autoroute metric
JUNOSe 11.1.x Command Reference Guide N to Z