Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 517 / 1488

■
circuit-ID-only—Specifies circuit ID suboption (suboption 1) only
■
remote-ID-only—Specifies remote-ID suboption (suboption 2) only
■
inhibit-access-route-creation—Specifies that host routes are not installed; enforces
consistent state of route/client database
■
In relay mode, removes all installed host routes from IP; deletes all host
routes data in the routing table and NVS; stops accumulating host route
information
■
In relay proxy mode, removes all installed host routes from IP; deletes all
NVS client data and stops installing host routes for newly bound clients in
IP; preserves the routing table client data and continues preservation of
newly bound clients in the routing table
■
discard-access-routes—Removes existing access routes from the routing table
and from NVS
■
all—Removes all existing access routes
■
interfaceType —Interface type whose access routes should be discarded; see
Interface Types and Specifiers on page 5
■
interfaceSpecifier —Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
■
unknown—Removes existing host routes from unknown (nonexistent)
interfaces—dynamic interfaces for which DHCP relay retains route information
after these interfaces have been deleted
Mode
Global Configuration
set dhcp relay
■ 475
Chapter 7: S Commands