Figure 8-8 Setting SVG parameters
Step 2 Add an SVG.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. Add an SVG.
Table 8-7 Adding an SVG
Path
Parameter
Setting
Choose
System
Settings >
Device
Management
and click Add
Device. The
parameters
for adding
devices are
displayed.
Device
attribute
Select PDU from the drop-down list box.
Device Type
Select SVG-In-Power from the drop-down
list box.
Connect To
Select ECC800 from the drop-down list
box.
Communicati
ons Port
Select COM2 from the drop-down list box.
Device
Address
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the SVG based on the actual
situation.
3. Click Test Connect to check whether the SVG connects to the ECC800-Pro
properly.
–
If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
–
If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
----End
ECC800 Data Center Controller
User Manual
8 FAQ
Issue 04 (2021-10-09)
Copyright © Huawei Technologies Co., Ltd.
311
