Hioki MR8827, Instruction Manual

Page: 192 / 436

187
9
Trigger Settings
Triggering allows you to start and stop measurement using signals or conditions. When recording is
started or stopped by a specific signal, we say the trigger is “applied” or “triggering occurs.”
You can configure triggers inform the Trigger settings window of the Waveform screen.
Triggers cannot be set with the X-Y Recorder function.
To Open the Trigger Settings Window
Pressing TRIG.SET repeatedly cycles
through the following sheets.
[Analog Trig]
[Logic Trig]
No display
If the trigger setting screen is hard to see due to waveform
overlap, narrow the waveform display width to divide the
waveform display screen and trigger settings screen.
Refer to “7.7.3 Switch the Waveform Display Width” (p. 136)
Operations available from the Trigger settings window
Logic Trigger Settings (p. 195)
•Combined trigger logic settings
• Trigger filter settings
•Trigger pattern settings
Analog Trigger Settings (p. 190)
• Level Trigger
•Window trigger
•Period trigger
•Glitch trigger
•Voltage sag trigger
Trigger Settings
• Trigger mode settings (p. 189)
• Combined trigger logic (AND/OR) for multiple
trigger sources (p. 206)
• Pre-trigger settings (p. 201)
• Trigger timing settings (p. 204)
Timer Trigger Settings (p. 197)
External Trigger Settings (p. 200)
Manual Trigger Settings (p. 200)
Trigger Output (p. 343) Search for trigger positions (p. 207)
Trigger Source Settings
9 Trigger Settings
9
Trigger Settings