Hioki MR8827, Instruction Manual

Page: 141 / 436

136
Switch the Waveform Screen Display (Display Menu)
7.7.1 Show Upper/Lower Limit on Waveform Screen
Select [Limit Value] to show the upper/lower limit value indication on the Waveform screen.
7.7.2 Show Comments on Waveform Screen
Select [Comment] to show the comment indication on the Waveform screen.
• Comment information must have been entered via the [Comment] sheet on the Channel screen.
Refer to “8.1 Add Comments” (p. 140).
• When they overlap with other displayed elements, the comments may not display properly. Hide the
Channel Settings Window, Trigger Settings Window, Level Monitor, etc., or decrease the [Wave Width] .
7.7.3 Switch the Waveform Display Width
Select [Wave Width] to change the display width of the Waveform screen.
If a waveform is hard to see because of numeric value and settings information, this function can be used
to separate the waveform and other information.
The function is also active for the Channel settings window and Trigger settings window.
7.7.4 Switch the Channel Range Information Display
Each time you press the
[<= Change Ch]
, the channel range information displayed at the lower part of
the screen changes between CH1 to CH16 and CH17 to CH32.
7.7.5 Switch the Displayed Sheet
Select [↑] / [↓] to switch the displayed sheet.
The settings of each displayed sheet can be specified on the Unit List tab of the Channel settings window.
Refer to “3.4.4 Displayed Sheet” (p. 67).