413
1) "Setup IP: Automatic" combo box: You can switch between automatic and
manual by pressing “down arrow button” or “up arrow button”. If you select
"Manual", you must enter your IP address, subnet mask, gateway IP address,
and DNS IP address. You can move among these computer edit boxes by
pressing “down arrow button” or “up arrow button”. Press “Tab” to move to
the next control.
2) "Network name (SSID)" computer edit box: Type the network ID in the
computer edit box.
3) "Network mode" combo box: You can select among "Infrastructure", and
"802.11 ad-hoc" mode by pressing “up arrow button” or “down arrow button”.
4) "Network authentication mode" combo box: Select among "Open",
"Shared", "WPA-PSK", and "WPA2-PSK" by pressing “up arrow button” or
“down arrow button”.
5) "Data encryption" combo box: Select the data encryption method by
pressing “up arrow button” or “down arrow button”. If you select "Open" or
"Shared" in network authentication mode, you can choose among "Disable"
and "WEP". And if you select "WPA-PSK" or "WPA2-PSK" in network
authentication mode, either "AES" or "TKIP" can be selected in the "Data
encryption" combo box.
6) "The key is provided automatically" check box: If the "access point" does
not provide a key for users automatically, uncheck this check box by
pressing "Space". The default is checked.
7) "Network key" computer edit box: This is a computer edit box to type the
network key if the key is not provided automatically.
8) "Key index" edit box: This is an edit box to type the key number of the
wireless access point that matches the network key input.
9) "Confirm" button: Pressing this button applies the changes.
10) "Cancel" button: You can press this button to cancel the setup.
Note:
1) If "Data encryption" has been set as "disabled", press "Tab" and you are
taken directly to the "Confirm" button.
2) "Network key" and "Key index" is displayed only if you uncheck "The key
is provided automatically".
