Standard function blocks
338
02/16 MN05013001Z EN
Entering the standard circuit diagram
X
Enter the following circuit diagram.
Figure 171: Wiring of counter and timing relay
Entering function block parameters
When entering the coils or contacts of a function block, the
inputs/outputs of the function block are displayed to which
you can assign parameters. The parameters can be entered
via the function blocks menu.
The meaning of these parameters is explained under each
function block type.
Entry:
The first part of the parameter set of a counter is displayed.
X
Move the cursor
í
over the + character to the value input
behind >SH:
– >SH means: Function block input upper counter
setpoint value.
– The + character means that the parameters of this
timing relay can be modified using the PARAMETERS
menu.
X
Change the upper counter setpoint to 10:
– Use
ú í
to move the cursor onto the tens digit.
– Use
ÍÚ
to modify the value of the digit.
X
Press OK to save the value and ESC to return to the circuit
diagram.
X
Set the parameters for T 01.
IS05---------------------------
Ä
C 01C
IS06---------------------------
Ä
C 01RE
C 01OF-------------------------
Ä
T 01EN
T 01Q1-------------------------
Ä
QS01
C 01 +
>SH +10
>SL
>SV
Summary of Contents for easySafety
