Eaton easySafety, Manual

Page: 605 / 695

Retention
601
02/16 MN05013001Z EN
Transferring retentive behaviour
The retentive behaviour setting is a standard circuit diagram.
In other words, the setting of the Retention menu is included
in any transfer on the memory card or when uploading/
downloading to/from the PC.
Changing the operating mode or the standard circuit
diagram
The retentive data is normally stored with its actual values
when the operating mode or the easySafety standard circuit
diagram is changed. The actual values of no longer used
relays are not retained.
Changing the operating mode
If you change from RUN to STOP and then back to RUN, the
actual values of the retentive data will be retained.
Changing the ea s ySafety standard circuit diagram
The actual values are retained if the easySafety circuit
diagram is changed.
Changing the startup behaviour in the SYSTEM menu
The retentive values in easySafety are retained irrespective of
the setting.
Modification of the retentive range
If the set retentive ranges are reduced, only the actual values
saved in the range will remain.
If the retentive range is extended, the older data is retained.
The new data is written with the current actual values in
RUN mode.