Eaton easySafety, Manual

Page: 29 / 695

ea s ySafety operation
25
02/16 MN05013001Z EN
Status display for the ea s ySafety basic unit
After power on, the easySafety device shows the status
display of the basic unit. The status display has four lines. If
you are operating a local expansion module via the easyLink
connection, show the status display of the local expansion
module on the display by pressing OK (
a
page 27).
Pressing ALT allows you to change the content of line 2 and
3 and the status display of the basic unit as well as the local
expansion. Three different types of information can be
shown.
Figure 2: Status display when you switch on
h
When operating the easySafety device as a NET station
you can press ESC to switch from the status display and
select another NET station. You can then display the status
of the inputs and outputs of the other NET station
(
a section “Displaying the status display of other
stations”, Page 546).
Inputs
1)
Weekday/Time or Weekday/Date
Outputs
1)
RUN/STOP/BUSY mode
1) On: IS1, 2, 5,14 and QR1, QS1, 4
Off:...
IS12..5.......14
P-
MO 11:50
QR1 QS1..4 STOP