ea
s
ySafety Settings
592
02/16 MN05013001Z EN
Startup behaviour
The startup behavior is an important aid during the commis-
sioning phase. The configuration contained in the easySafety
is not fully wired and parameterized. Or the plant/machine is
in a state that easySafety cannot control. If easySafety is
then switched on, it should not be possible to activate the
outputs.
Setting the startup behaviour
Requirement: easySafety must contain a valid configuration.
X
Change to the system menu via -> STD PARAMETERS ->
SYSTEM.
Set whether easySafety should start in RUN or STOP mode
when the power supply is switched on.
h
To change to RUN mode without using the configuration
software the startup behaviour RUN START must be
enabled for easySafety devices without display.
h
If easySafety is password protected, easySafety the system
menu area cannot be accessed until has been unlocked
(
Summary of Contents for easySafety
