Eaton easySafety, Manual

Page: 298 / 695

Standard function blocks
294
02/16 MN05013001Z EN
Wiring of the function block
You wire the function block in the standard circuit diagram
with its trigger coil and its contacts.
Example of a PUT function block:
Figure 136: Wiring the trigger coil
The trigger coil is connected to a device input.
Figure 137: Wiring the function block contacts
The contacts transfer the function block information to
markers.
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
The parameters consist of the following:
IS05--------------------------
Ä
PT07T_
PT07Q1---------------------------
Ä
M 11
PT07AC---------------------------
Ä
M 22
PT07E1---------------------------
Ä
M 33
PT07 -
>I1
PT07
Function block: PUT, number 07
-
Parameter display: Call not enabled
>I1
Input value that is to be put onto the NET