Safety function blocks
512
02/16 MN05013001Z EN
Enable
The enable coil ZM..EN allows the selective activation or
deactivation of the function block. Further information can
be found at section “Enable parameter, EN enable coil” on
page 345.
The default setting for this parameter is NEN; the function
block is active without an external enable.
Operating mode
After easySafety has determined the conditions for safe
operation, there are different kinds of restarts possible. They
are described in greater detail as operating modes in chapter
“Operating mode parameter, RE reset coil” on page 346.
The factory setting of this parameter is MST, Manual Start.
Parameters
Function, parameterisation in the func-
tion block
EN
External enable required
NEN
No external enable required
Parameters
Function, parameterisation in the func-
tion block
AST
Automatic start, no manual restart
MST
Manual start
CST
Controlled start
Summary of Contents for easySafety
