Eaton easySafety, Manual

Page: 233 / 695

D, text display
229
02/16 MN05013001Z EN
Entering setpoints via keypad/display
The function block setpoints shown on the display and which
can be defined as constants can be edited. The possibility of
editing must be activated in the programming software. The
values can be 4, 5, 7 and 11 places long. Incorrect entries
can cause characters to be overwritten or hidden.
Function
The text is output if you activate the EN coil. For this the
status display must be active before the text display is called.
If the coil (EN) is returned to 0, the control relay display
reactivates the status display after 4 s.
The additional Central Europe and Cyrillic fonts can also be
used for the text display and combined with the display
attributes Flashing and Inverse. These options can be set for
individual lines, and the attributes can be used in any
combination.
Different behaviour of the function blocks D01 and
D02 to D16
D01 outputs an alarm text: If D01 is activated, the text
assigned to it will be displayed until:
• The coil D01 is reset to 0.
• STOP mode is selected.
• The easySafety device is switched off.
• The OK or DEL + ALT buttons are used to switch to a
menu.
Variable Format
Timing relays s s s . s s s
min min : s s
h h : min min
Time h h : min min
Date DD.MM : YYYY