ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 60 / 366

48 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Installation
Install the SuperTrak Conveyance Platform
Complete the procedures in this section in the order that they are written.
1. Calculate the space required to install the SuperTrak conveyance platform, to
verify that there is adequate space.
2. Complete one (1) of the following, depending on the type of frame that is used:
• Install the SuperTrak conveyance platform on a SuperTrak GEN3 frame.
See Install the SuperTrak Conveyance Platform on a SuperTrak GEN3
Frame on page 49.
• Install the SuperTrak conveyance platform on a custom frame.
See Install the SuperTrak Conveyance Platform Sections with
Custom Stands on a Custom Frame on page 50.
• Install the SuperTrak conveyance platform in an over/under
configuration.
See Install the SuperTrak Conveyance Platform in an Over/Under
Configuration on page 64.
3. Install the required cable connections.
See Connections on page 116.
4. Verify that the upper v-rail is adequately lubricated.
If required, add an additional 20 drops of lubricant to the pallet lubrication felt,
or manually wipe lubricant on the upper v-rail. Remove excess oil from the
SuperTrak that may have dripped from the upper v-rail.
• Make sure the installation is done on a non-compressing surface (for
example; concrete), so the sections can be leveled and aligned
correctly.
• The maximum number of sections in a SuperTrak system is based on
the gateway communication network’s maximum capacity of sixty-
four gateways. Each straight, 90 deg., and 1980 deg. (500 mm)
section contains one gateway while each 180 deg. (800 mm) section
contains two gateways. Therefore, a system using straight sections
with only 180 deg. (500 mm) or 90 deg. sections could have sixty-
four sections total, while a system using 180 deg. (800 mm) sections
would be limited to sixty-two total sections.