ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 212 / 366

200 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Install the Pallet Flat Wheels
1. Hold a spacer on each side of the bearing
of the new flat wheel and insert the flat
wheel into the pallet body.
For ease of assembly, rest the pallet on
the shoulder screws or upside down on
the encoder strip assembly.
2. Align the spacer and flat wheel with the
hole in the pallet body.
3. Position a dowel over the pallet body hole
with the flat side of the shaft facing the
set screw.
4. Attempt to manually push the shaft in.
If tight, use a mallet to gently tap the
shaft until the top of the shaft is flush with
the pallet body.
5. Repeat steps 1 to 4 for the second flat
wheel.
6. Fully remove the set screws, to verify that
the flat of the shaft is aligned with the set
screw.
If the set screw contacts the round of the
shaft, it can score the shaft and make it
difficult to remove the shaft later.
7. Install and tighten the two (2) wheel set
screws.