ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 225 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 213
Rev. 9 (12-2021)
4. Lift and remove the pallet encoder strip
assembly.
5. Obtain a replacement encoder assembly with a new encoder strip mounted.
Order this part from ATS.
6. Align the pallet encoder strip assembly that has a new encoder strip with the
pallet.
7. Secure the pallet encoder strip assembly in position with two (2) screws, two
(2) lock washers, and two (2) flat washers.
8. Align the pallet encoder strip assembly.
See Adjust the Pallet Encoder Strip Assembly (Primary Encoder Strip) on
page 226.
9. Install the pallet on the SuperTrak.
See Install a Pallet on page 191.
10. Verify that a 0.5 mm (0.02 in.) +/- 0.3 mm (0.01 in.) gap exists between the
pallet encoder strip assembly and the encoder assembly.
If the gap is less than 0.5 mm (0.02 in.) +/- 0.3 mm (0.01 in.), see Adjust a
Pallet Shim on page 207.