ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 194 / 366

182 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
2. As applicable, remove the black wire plug from the curved section:
• For the 180 deg. (500 mm)
section, the wire plug is located at
the bottom.
• For the 180 deg. (800 mm)
section, the wire plug is located on
the back (inside).
• For the 90 deg. section, the wire
plug is located on the back
(inside) at the bottom to the left
of center.
3. Feed the four (4) cables of the interconnect cable through the plug opening on
the curved section.
4. Secure the threaded end of the interconnect cable in the plug opening of the
curved section using the supplied lock nut.