ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 279 / 366

Troubleshooting
SuperTrak™ GEN3 System Operation and Maintenance Manual 267
Rev. 9 (12-2021)
Diagnostic Lights
This section provides information about the indicator lights on the SuperTrak
conveyance platform hardware.
Controller Indicator Lights
The controller has four (4) indicator lights: Power, HDD, Link, and Run.
The following table summarizes the indicator light behavior.
See the APC910 User’s Manual for additional information.
Indicator Color Light State Normal A Problem May Exist
Power Green Solid

Blinking A controller hardware problem exists.
Contact your vendor for assistance.
Red Solid The controller power is OFF. Press the
power button to turn it ON.
Blinking A controller hardware problem exists.
Contact your vendor for assistance.
Red/
Green Blinking
HDD Yellow Occasional
Blink

Link Yellow Solid Normal when an
SDL display is
connected.
Blinking SDL display power was interrupted.
Check the cables.
Off Normal when an
SDL display is not
connected.