ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 218 / 366

206 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Replace a Pallet Anti-Static Brush
The nominal length of a new anti-static brush is 4.05 mm (0.159 in.). When
0.5 mm (0.02 in.) of the anti-static brush is worn away, it will not make contact
with the upper v-rail. Replace an anti-static brush if more than 20% of the brush
bristles are worn away.
Remove an Anti-Static Brush
1. Remove the pallet from the SuperTrak conveyance platform.
See Remove a Pallet on page 193.
2. Remove the two (2) screws that secure
the anti-static brush in position.
3. Remove the anti-static brush.
Install an Anti-Static Brush
1. Align the new anti-static brush with the
outer holes of the anti-tip block.
Make sure the bristles of the anti-static
brush face up, toward the V-wheel.
2. Install two (2) screws to secure the anti-
static brush in position.
The anti-static bristles can be bent out of shape if mishandled. Take care
not to damage the anti-static bristles during this procedure.