ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 228 / 366

216 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
1. Install a pallet setup stationary mount on a straight section.
See Install a Pallet Setup Stationary Mount on page 217.
2. Optionally, for systems that require tight tolerances, verify that the pallet setup
stationary mount is parallel with the upper-v-rail.
See Verify Pallet Setup Stationary Mount Parallelism on page 218.
3. Center the pallet setup stationary mount with an encoder on the straight
section encoder assembly.
See Center a Pallet Setup Stationary Mount with an Encoder on page 219.
4. Verify that the pallet setup stationary mount is in the correct position.
See Verify the Pallet Setup Stationary Mount Position on page 223.
The pallet setup stationary mount is now centered with an encoder on the
straight section.
5. Determine the distance between two encoders.
See Reference the Encoder Position on page 225.
6. If required, center the encoder assembly with the center of the pallet.
See Adjust the Pallet Encoder Strip Assembly (Primary Encoder Strip) on
page 226.
7. If required, align the secondary encoder strip with the primary encoder strip.
See Adjust a Secondary Encoder Strip on page 227.