ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 237 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 225
Rev. 9 (12-2021)
Reference the Encoder Position
Complete this procedure to measure the physical distance between two encoders
on the straight section encoder assembly.
Redo this procedure if an encoder assembly is replaced on a straight section that
has a stationary mount installed.
1. Complete steps 1-4 of Verify the Pallet Setup Stationary Mount Position on
page 223.
2. Click the Reference Setup tab.
3. Click the encoder that the stationary mount is aligned with.
4. Click Capture Live Counts .
The primary reference values display.
5. Click Begin Sweep .
6. Remove the pallet from the pallet setup removable locate:
a. Loosen the side thumb screw to release the pallet.
b. Raise the side thumb screw.
c. Slide the pallet to the right (~15 cm [~6 in.]).
TrakMaster calculates and displays the secondary reference values.
7. Click Save Parameters , located in the top right of the screen.
Encoder Configuration is selected by default on the Save Configuration dialog.
8. Click OK .
9. Note the following information for your records: your name, date, the pallet
number that was used for the procedure, and the removable locate number.