ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 255 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 243
Rev. 9 (12-2021)
Replace a Motor Cover Label
Each motor includes a protective motor cover label. This is the black label with the
SuperTrak conveyance platform logo in the bottom left corner. Replace the motor
cover label if it becomes damaged.
Remove the Damaged Motor Cover Label
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Peel off the old cover label.
4. Clean off any adhesive residue from the motor face.
Use an adhesive residue cleaner (such as Goo Gone) to remove the adhesive
residue, and then clean the motor with isopropyl alcohol or equivalent so the
new cover label adheres correctly.
Install a New Motor Cover Label
1. Peel off the backing from the new motor cover label.
2. Align the top of the motor cover label with
the top edge of the motor.
3. Slowly tilt the motor cover label toward the motor until it is adhered to the
motor.
4. Starting from the center of the motor cover label, run your hands over the label
to remove any air pockets.
5. Trim away any portions of the motor cover label that extend past the edge of
the motor.