ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 169 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 157
Rev. 9 (12-2021)
Replace a Gateway Board
This section describes how to replace a gateway board in a straight section, 90
deg. section, or in a 180 deg. section
Remove a Gateway Board - Straight Section, 90 Deg. Section, or 180 Deg.
(800 mm) Section
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Use a flat head screwdriver to unlock the
lock screws to open the electrical door
access.
• Straight section (pictured at
right)
--there are five lock screws
on the access door.
• 180 deg. (800 mm) section --there are two gateway boards, one in the
right and one in the left electrical compartment. Unlock the four screws
on the access door where the gateway board you want to replace is
located.
• 90 deg. section --the gateway board is located in the left of the two
electrical compartments. Unlock the six screws on the left-side access
door.
4. Unplug the two (2) 24V digital power
connections.
To prevent electrical board damage from electrostatic discharge (ESD),
use an ESD wrist strap when working with the gateway board. An ESD
wrist strap prevents the buildup of static electricity.