ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 62 / 366

50 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Installation
Install the SuperTrak Conveyance Platform Sections
with Custom Stands on a Custom Frame
This section describes how to install SuperTrak conveyance platform sections on
custom stands and a custom frame in cases where the SuperTrak system is not
provided assembled and configured with stands. ATS stands and an ATS frame are
shown for reference.
1. Inspect the frame to verify that it includes the correct features outlined in the
SuperTrak conveyance platform Mechanical Drawings.
2. Position the frame on a flat non-compressing surface.
3. If custom stands are used with straight sections, install those stands;
otherwise, proceed to step 4:
a. Inspect the stands to verify that they include the correct features
outlined in the SuperTrak GEN3 Design Considerations document.
This procedure assumes that the Y-axis movement of the custom
stands is
≤ 0.002 in. ( ≤ 0.05 mm) when the stands are parallel, the
stands allow for Y-axis and Z-axis adjustment, and the stands include
the correct hole pattern.
b. Lift the section.
See Lift a SuperTrak Conveyance Platform Section on page 74.
c. As required, attach the stands to the straight sections.
Always use appropriate lifting devices (for example, a forklift or crane)
and use safe lifting practices and procedures when lifting a straight or
curved section.
See
Lift a SuperTrak Conveyance Platform Section on page 74.
ATS recommends that you obtain relevant information from your national
Health and Safety Authority.
Make sure the custom frame is designed to hold the weight and force of
the SuperTrak conveyance platform sections.
• This procedure assumes that the Y-axis movement of the custom
stands is ≤ 0.002 in. ( ≤ 0.05 mm) when the stands are parallel, the
stands allow for Y-axis and Z-axis adjustment, and the stands include
the correct hole pattern.
• This procedure assumes that the custom frame includes the correct
hole pattern on the top and sides of the frame.
See the SuperTrak conveyance platform Mechanical Drawings and the
SuperTrak GEN3 Design Considerations documents for additional
information.