ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 168 / 366

156 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Install a Coil Driver Board - 180 Deg. Section (500 mm)
If required, reference Straight Section - Left Coil Driver Board on page 28, and Left
Coil Driver Board with a Power Supply Connected on page 29 during this procedure.
1. Remove the old coil driver board.
See Remove a Coil Driver Board - 180 Deg. Section (500 mm) on page 152.
2. Inspect the new coil driver board, to make sure it contains ten (10) 15 A fuses.
3. Align the coil driver board with the screw holes inside the straight section or
180 deg. section.
4. Secure the coil driver board in position
with fourteen (14) screws.
Make sure that the screw in the upper
left corner of the coil driver board is
nylon.
5. Connect the five (5) coil plugs.
6. Connect the two (2) ribbon cables.
7. Connect the three (3) thermistor connections.
• To prevent electrical board damage from electrostatic discharge
(ESD), use an ESD wrist strap when working with the coil driver
board. An ESD wrist strap prevents the buildup of static electricity.
• During installation, take care not to pinch wires when the coil driver
board screws are installed. This can cause an electrical short.