ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 253 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 241
Rev. 9 (12-2021)
Align a Flat Wear Strip
Adjustment tooling, located under the curved section, provides in-and-out
adjustment of the flat wear strip on the curved section. The process for aligning
the flat wear strips varies slightly depending on the type of curved section, as
outlined below.
180 Deg. (500 mm) Section
1. Loosen the two (2) screws that secure the flat wear strip adjustment tooling in
position
2. Turn the adjustment knob as required, until the flat wear strip on the curved
section aligns with the flat wear strip on the straight section.
3. Tighten the two (2) screws from step 1.
180 Deg. (800 mm) Section
If the wear strip is protruding, remove
the wear strip spacer and grind the
back face as needed.