ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 174 / 366

162 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Install a Gateway Board - Straight Section, 90 Deg. Section, or 180 Deg.
(800 mm) Section
If required, reference Gateway Board on page 30 during this procedure.
1. Remove the old gateway board:
See Remove a Gateway Board - Straight Section, 90 Deg. Section, or 180
Deg. (800 mm) Section on page 157.
2. Assemble the gateway board:
a. Install a toothed washer on each
of the four (4) screws.
b. Install flat washer on each of the
four (4) screws.
c. Insert each of the four (4) screws
through the gateway board.
d. Install three (3) white plastic
spacers on the end of each of the
four (4) screws.
Make sure the spacers are within a thread or two of the end of the
screw.
3. Align the screws in the gateway board
with the threaded holes inside the straight
section.
To prevent electrical board damage from electrostatic discharge (ESD),
use an ESD wrist strap when working with the gateway board. An ESD
wrist strap prevents the buildup of static electricity.