ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 165 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 153
Rev. 9 (12-2021)
6. Remove the fourteen (14) screws that
secure the board to the bus bar.
7. Disconnect the three (3) thermistor
connections.
Squeeze the tabs for each thermistor
connector plug and then pull straight out.
8. Lean the coil driver board forward and lift straight up.
Remove a Coil Driver Board - 180 Deg. Section (800 mm)
or 90 Deg. Section
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Use a flat head screwdriver to remove the screws from the electrical door, and
then set the electrical door aside.
4. Remove the gateway board.
Complete steps 4 to 9 of the Remove a Gateway Board - Straight Section, 90
Deg. Section, or 180 Deg. (800 mm) Section on page 157.
5. Remove the coil driver board.
Complete steps 4 to 7 of the Remove a Coil Driver Board - Straight Section on
page 150.
To prevent electrical board damage from electrostatic discharge (ESD),
use an ESD wrist strap when working with the coil driver board. An ESD
wrist strap prevents the buildup of static electricity.