ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 249 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 237
Rev. 9 (12-2021)
9. Verify joint alignment on both ends and adjust if necessary.
See Fine-Adjust the Upper V-Rail on page 103.
10. Calibrate the encoders.
See the TrakMaster built-in help for the calibration procedure.
Install an Upper V-Rail - 180 Deg. Section 180 Deg. (500 mm) Section
1. Hold the new 180 deg. top plate horizontally with the counter-bore side up.
2. Position the top plate down onto the top of
the 180 deg. section.
The top plate must align with features in
the top of the 180 deg. section.
To prevent damage to the RJ11
connections, make sure the cables are
aligned with the RJ11 openings in the top
plate.
3. Install eleven (11) screws to secure the top plate in position.
4. Align the top cover on the 180 deg. section.
5. Install ten (10) screws and ten (10) washers to secure the top cover in
position.
6. Reinstall the left and right encoder assemblies.
See Replace an Encoder Assembly on page 165.
7. Verify joint alignment on both ends and adjust if necessary.
See Fine-Adjust the Upper V-Rail on page 103.
8. Calibrate the encoders.
See the TrakMaster built-in help for the calibration procedure.