ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 252 / 366

240 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
3. If required, install a locator:
a. Align the locator with the slot of the SuperTrak conveyance platform
section so that the tab faces the long opening. The screw hole is not
centered in the slot, one side of the slot is longer than the other.
b. Install a screw to secure the
locator in position.
4. Align the flat wear strip slot with the
locator tab.
5. Release the flat wear strip. The channel magnets pull the flat wear strip into the
channel.
6. If the flat wear strip does not sit flat in the channel, adjust the locator position:
a. Loosen the locator screw.
b. As required, slide the locator left or right.
c. Tighten the locator screw.
7. If the flat wear strip join between a straight section and a 180 deg. section
does not sit flat, see Align a Flat Wear Strip on page 241.