ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 175 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 163
Rev. 9 (12-2021)
4. On each of the four (4) corners of the
gateway board, verify that the gateway
board sits flat on the white plastic
spacers.
5. Secure the gateway board in position with
four (4) screws. To prevent distortion of
the gateway board, tighten one (1) screw
at a time, working around the board in a
clockwise direction.
Depending on how the screws and white
spacers bind, it may be necessary to
tighten each screw a thread at a time.
6. Torque each of the four (4) screws to
18 lbf-in (2 Nm).
7. Reconnect the cables to the gateway board:
a. Connect the two (2) encoder
cables (right and left).
b. Connect the four (4) ribbon
cables.
c. As required, connect one (1) or
two (2) motor network connection
cables.
d. Connect the two (2) 24V digital
power connections.
8. Close the electrical door, and then lock the five (5) locks with a flat head
screwdriver.