ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 220 / 366

208 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
2. If the gap is greater than 0.5 mm (0.02 in.) +/- 0.3 mm (0.01 in.), verify that
the pallet shim is the problem (not the v-wheels or pallet encoder strip
assembly):
• Make sure that the v-wheels are secure with no vertical play. If the
v-wheels have vertical movement; secure the v-wheels in position, and
then re-measure the encoder strip gap.
• Make sure that the encoder strip assembly is secure and flush with the
encoder assembly. If required; replace the encoder strip assembly, and
then re-measure the encoder strip assembly gap.
See Replace a Pallet Encoder Strip Assembly on page 212.
3. Remove the two (2) outer set screws, located on the side of the pallet.
4. Loosen the two (2) inner set screws, located on the side of the pallet.
5. Remove the two (2) screws, two (2) lock
washers, and two (2) flat washers that
secure the pallet encoder strip assembly
in position.
6. Lift and remove the pallet encoder strip
assembly.