ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 164 / 366

152 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
Technician Procedures
Remove a Coil Driver Board - 180 Deg. Section (500 mm)
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Remove ten (10) screws and ten (10)
washers from the top cover of the 180
deg. section, and then lift and remove the
top cover.
4. Unplug the two (2) ribbon cables.
Pull each of the four (4) ribbon cable plugs
straight out.
5. Unplug the five (5) coil plugs.
Pull each coil plug straight out.
To prevent electrical board damage from electrostatic discharge (ESD),
use an ESD wrist strap when working with the coil driver board. An ESD
wrist strap prevents the buildup of static electricity.