ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 219 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 207
Rev. 9 (12-2021)
Adjust a Pallet Shim
The pallet shim is factory-set to obtain a 0.5 mm (0.02 in.) gap between the pallet
encoder assembly and the SuperTrak conveyance platform encoder assembly. Adjust
the pallet shim if the gap is outside of the range of 0.5 mm (0.02 in.) +/- 0.3 mm
(0.01 in.).
1. With the pallet installed, measure the gap between the pallet encoder strip
assembly and the SuperTrak conveyance platform:
a. Place a 0.5 mm (0.02 in.) plastic shim on the aluminum surface of the
encoder assembly. Do not place the shim over a pallet encoder strip
assembly.
b. Slide the pallet over the shim.
c. Use different size shims to
determine if the gap is greater or
less than 0.5 mm (0.02 in.), and
by how much.