ATS SuperTrak GEN3, Operation And Maintenance Manual, Page: 61 / 366

Installation
SuperTrak™ GEN3 System Operation and Maintenance Manual 49
Rev. 9 (12-2021)
Install the SuperTrak Conveyance Platform on a
SuperTrak GEN3 Frame
1. Install the first SuperTrak conveyance platform section.
See Install the First SuperTrak Conveyance Platform Section on page 92.
2. Install the next SuperTrak conveyance platform section.
See Connect Two SuperTrak Conveyance Platform Sections Together on page
96.
3. Repeat the preceding step until all SuperTrak conveyance platform sections are
connected together.
4. Verify that a 0.5 mm (0.02 in.) gap still exists between all sections.
In the example below, the gap is checked in twenty (20) locations: at the top
and bottom of each section join that is indicated by an arrow.
See step 7 from Connect Two SuperTrak Conveyance Platform Sections
Together on page 96, if additional information is required.
5. Align the SuperTrak conveyance platform section joints.
See Align the SuperTrak Conveyance Platform Section Joints on page 98.
6. Align the SuperTrak conveyance platform section heights.
See Align the SuperTrak Conveyance Platform Section Heights on page 99.
7. Install the wedge adjust.
See Install a Wedge Adjust on page 100.
8. Align the upper v-rail.
See Replace an Upper V-Rail on page 230.
9. Install the lower flat wear strips.
See Replace a Flat Wear Strip on page 238.
10. Install the pallets.
See Install a Pallet on page 191.
11. If required, fine-adjust the upper v-rail.
See Fine-Adjust the Upper V-Rail on page 103.