OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
166
Fig. 192
Fig. 191
8.2.4
WHEEL TRACK ADJUSTMENT
The rim is assembled in such a way that the connective plate is asymmetrically welded to the
arch to allow the base plate to be attached in two different positions.
•
If the base plate is turned to the other side of the connective plate, the rim and the base
plate can be positioned in four ways, see Fig. 191.
•
By turning the entire rim on the wheel hub, you can adjust it to eight positions between
the centre of the wheel and the contact surface of the hub. This means you can adjust the
wheel track to four different widths, refer to the chapter “Wheel dimensions”.
•
Before adjusting the rim, check the tyre dimensions that can be installed to prevent the
wheel from colliding with other parts of the tractor, refer to the chapter “Wheel
dimensions”.
Rim assembly
1.
Rim
2.
Base plate
3.
Connective plate
4.
Fastening bolt (spring washer and nut)
Summary of Contents for AGT 106
