OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
174
Fig. 203
Rear stop lamp
The light bulb type for the stop lamp is P21 12V 21W (double filament). To replace the light
bulb in the lamp, perform the procedure described below.
•
Unscrew the screws (A) under the lamp housing on the fender and remove the protective
cover.
•
Disconnect the connector from the lamp.
•
Rotate the bulb holder (B) on the lamp to the left and remove it.
•
While holding the holder, gently push the bulb (C), rotate it all the way in anti-clockwise
direction and pull it out.
•
Replace the old bulb with a new one. Insert it all the way into the holder and install it by
slightly pushing and rotating the bulb in a clockwise direction.
•
Insert the holder with the bulb back into the lamp and rotate it to the right to fasten it.
•
Connect the connector to the lamp.
•
Reinstall the protective cover and tighten the screws (A).
IMPORTANT:
Only use light bulbs with technical characteristics matching the
original light bulbs!
Summary of Contents for AGT 106
