OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
120
Fig. 139
6.3.3.1
STANDARD TOP LINK
The standard top link is mechanically operated and manually adjusted according to the procedure
below.
•
Release the safety lever (1).
•
The top link is extended by rotating the handle (2) on the central part of the bar in the
clockwise direction and retracted by rotating in the opposite direction.
(This only applies when the top link is attached to the tractor with the safety lever is at
the side of the implement. If the top link attachment is reverse, the adjustment direction
by rotating the lever is also reversed.)
•
After adjusting the desired top link length, screw the safety lever (1) back and block the
rotation of the handle on the central part of the top link bar (2).
6.3.3.2
HYDRAULIC CONNECTION ROD
The lift rod is adjusted with a hydraulic control lever on the control device.
•
The lift rod is retracted or extended by moving the control lever up and down to position
1 or 2 and the direction of operation depends on the connection of hydraulic couplings.
•
In position 3, the lever is not functional and the hydraulic connection rod is not moving.
•
When you adjust the desired length of the connection rod, move the control lever to
position 0 to block the rod in place.
WARNING:
After the adjustment of the top link is completed, always make sure
that the safety lever is tightened before starting to work!
WARNING:
Never extend the top link too much, to the point that only a
minimum thread length remains on the connection parts on the bar, otherwise they
could fall out when loaded and cause serious accidents during work.
Summary of Contents for AGT 106
