OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
197
Fig. 235
8.9
BRAKING SYSTEM MAINTENANCE
Before performing any maintenance work on the braking system, comply with the instructions
described below.
•
Stop the tractor in safe conditions and in a suitable area.
•
If the tractor was operating, wait until the engine cools down enough.
•
Lower the hydraulic lift system to the ground; lower the implement, if attached.
•
Remove the key from the ignition lock.
8.9.1
CHECKING THE BRAKE AND CLUTCH OIL LEVELS
If the oil level drops below minimum, the warning light will illuminate on the dashboard, refer to
the chapter “Dashboard”. For this reason, you must check the oil level and top it up if necessary.
The tank is located at the top of the rear side of the console, under the external plastic covering.
To check the oil level, follow the procedure described below.
•
Loosen the screws (A) on the console joint.
•
Remove the cover from the rear part of the console.
•
Check the oil level in the tank (B), which must reach the marking on the edge.
•
If necessary, add more oil, but not beyond the maximum mark.
•
After the work is finished, install the cover and tighten the screws.
IMPORTANT:
Add oil with suitable characteristics, meeting the requirements,
refer to the chapter “Technical data of the tractor - oil”.
Summary of Contents for AGT 106
