OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
13
Fig. 6
Fig. 7
2.4
SAFETY INSTRUCTIONS BEFORE USING THE TRACTOR
Before using the tractor, always check if all safety devices (safety belt, roll bar etc.) are correctly
installed (securely attached) and functional. Only use the tractor with original parts and safety
devices installed by the manufacturer.
Before commencing work with the tractor, make sure the following conditions have been
fulfilled:
•
Before operating the tractor, become familiar with all controls, which must be within
reach and always set in neutral position until the tractor is operated or started.
•
Perform a visual inspection of the tractor; check if all the parts and equipment are
securely installed and undamaged:
−
check that the brakes, including the parking brake are in proper working order;
−
check the operation of the hydrostatic control system;
−
check the oil level and top up if the level is low;
−
check the condition of the electric system (battery, wires, headlamps, warning
lamps etc.).
•
Perform a visual inspection of tractor tyres before operating the tractor.
−
Check the tyre pressure and adjust if not properly inflated.
−
Check for potential damage, such as bulges or cuts.
−
Check the tyre tread for wear.
•
Only check the tyre pressure when implements or ballast weights are detached.
•
Make sure the main tractor components are clean, remove any dust or debris from the
engine, the radiator, the tank etc. and prevent potential fire risks.
•
The tractor can be entered laterally, from both sides;
never
enter the tractor from anywhere else than the dedicated entrance
points, otherwise there is a risk of serious injuries due to falling
(Fig. 6).
•
Make sure the surfaces and foot supports are clean and free
from dirt, oil, dust etc. before entering the tractor. During
winter, always remove any ice or snow before entering.
•
Use the handhold and the footstep to enter the tractor. Never
hold on to the gear shift lever and do not step on the pedals
when entering the tractor.
•
Always use the “three-point grip” principle - both feet and one
hand or one foot and both hands when climbing on and off the
tractor.
•
Ensure a good ergonomic position (seat, steering wheel and
rear-view mirrors); before use, the space must be tidy and
ensure an optimum field of view, without limitations.
•
Before operating a tractor with a cab, make sure all the
windscreens are clean.
•
Only start the tractor when seated on the driver's seat (Fig. 7).
•
The driver's seat can be rotated according to the desired driving
direction (forward or reverse);
•
Only rotate the seat when the tractor is stopped, NEVER perform
this operation during driving.
•
The area with the seat rotation plate must be clean and correctly
locked, so that the seat is securely fixed and will not lift in the event of a tractor rollover.
Summary of Contents for AGT 106
