OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
114
Fig. 129
Fig. 130
6.2.3
ADJUSTING THE WORKING LAMPS (VERSION WITH A CAB)
Adjusting the lamps up and down
, this adjustment can be performed manually. If this is not
possible, do the following:
•
First, loosen the screw on the articulated part of lamps.
•
Manually adjust the position of lamps to reach the desired illumination angle.
•
Tighten the screw.
Adjusting the lamps to the left/right
, this adjustment can be performed manually. If this is not
possible, do the following:
•
Move the working lamp upwards. If this is not possible, repeat the procedure described
above for adjusting the lamps up and down.
•
Loosen the screw next to the rear working lamp.
•
Manually adjust the position of lamps to the desired position.
•
Tighten the screw.
IMPORTANT:
These lamps should only be used as assistance when performing
work. When driving on the road, these lights must be turned off to avoid blinding
the other drivers.
Summary of Contents for AGT 106
