OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
214
8.12.7
PTO DRIVE SHAFT MALFUNCTION
Malfunction
Cause
Solution
The PTO drive shaft does not
rotate.
The solenoid valve fuse is faulty.
Replace the fuse. Refer to the chapter
“Fuses”.
The solenoid valve for PTO
drive shaft engagement is faulty.
Check the valve and replace it if
necessary. This operation can only be
performed by an authorized service centre.
(*)
The electrical wiring of the
solenoid valve is faulty.
Consult an authorized service technician.
(*)
The PTO drive shaft switch is
faulty.
Replace the switch. This operation can
only be performed by an authorized
service centre. (*)
One of the control levers for the
PTO drive shaft is in neutral
position.
Move the lever to engage. Refer to the
chapter “Operating controls”.
The driver is not in the driver's
seat.
Sit on the driver's seat. Refer to the
chapter “Starting the tractor”.
Malfunction of the external
switch for PTO drive shaft
engagement.
The engagement procedure through the
external switch was not carried out
properly. Refer to the chapter “PTO drive
shaft engagement”.
The parking brake is not activated. Refer
to the chapter “PTO drive shaft
engagement”.
The switch is faulty and must be replaced.
This operation can only be performed by
an authorized service centre. (*)
The universal joint clutch is
slipping.
The contact plates of the clutch
are worn.
Repair the clutch. This operation can only
be performed by an authorized service
centre. (*)
The soft start damper is faulty.
Replace the damper. This operation can
only be performed by an authorized
service centre. (*)
The solenoid valve for the PTO
drive shaft engagement is faulty.
Replace the valve. This operation can only
be performed by an authorized service
centre. (*)
The front PTO drive shaft does not
engage (installed as optional
equipment).
The fuse is faulty.
Replace the fuse. Refer to the chapter
“Fuses”.
The solenoid valve for the PTO
drive shaft engagement is faulty.
Replace the valve. This operation can only
be performed by an authorized service
centre. (*)
The PTO drive shaft switch is
faulty.
Replace the switch. This operation can
only be performed by an authorized
service centre. (*)
Malfunction of the external
switch for PTO drive shaft
engagement.
The engagement procedure through the
external switch was not carried out
properly. Refer to the chapter “PTO drive
shaft engagement”.
The parking brake is not activated. Refer
to
the
chapter “PTO drive shaft
engagement”.
The switch is faulty and must be replaced.
This operation can only be performed by
an authorized service centre. (*)
(*) - These operations should only be performed by an authorized service technician!
Summary of Contents for AGT 106
