OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
150
Fig. 175
To disconnect the implement from the tractor, follow the procedure below.
•
Stop the tractor in safe conditions.
•
Lower the support legs on the implement (if equipped).
•
Lower the implement to the ground using the lever on the control device.
•
Shut off the tractor’s engine.
•
Disconnect all electrical and hydraulic connections from the connection system on the
tractor.
•
Remove the top link from the third linkage point on the implement by releasing the safety
pins and the bolts on both sides. Store the top link in a suitable place.
•
Release the safety guard on the automatic linkage and disconnect the lower link arms
from the ball joints on the implement.
•
Remove the implement.
WARNING:
When attaching the implement, take care to avoid crushing of body
parts!
WARNING:
The manufacturer prepared an assessment of risks, which are only
applicable for the tractor without an implement installed or in combination with an
implement determined by the manufacturer. The operator must therefore be
familiar with all the risks which may occur when installing an implement not
prescribed by the manufacturer of the tractor and must take full responsibility in
case of an accident!
Summary of Contents for AGT 106
