OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
192
Fig. 228
Fig. 199
8.7.6
CHECKING THE OIL IN LATERAL REDUCERS
To check the oil in lateral reducers, follow the procedure described below.
•
Park the tractor on a horizontal surface,
shut off the engine and activate the
parking brake.
•
Lift the tractor on the side where you
intend to perform the check, support the
tractor with a suitable support stand and
remove the wheel.
•
Rotate the lateral reducer until the drain
screw (1) is positioned vertically at the
top and the control screw (2) is at the
right side of the reducer.
•
Loosen the control screw. The oil level
must reach the bottom edge of the screw
opening. If necessary, add more oil,
refer to the chapter “Changing the oil in
lateral reducers”.
•
After the work is finished, install and tighten the control screw back in its place.
WARNING:
Used oil must not be disposed of in the environment. In accordance
with applicable regulations, it must be collected in suitable collection containers.
Summary of Contents for AGT 106
