OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
193
Fig. 229
Fig. 230
8.7.7
CHANGING THE OIL IN LATERAL REDUCERS
To change the oil in lateral reducers, follow the procedure described below.
•
Park the tractor on a horizontal surface, shut off the engine and activate the parking
brake.
•
Lift the tractor on the side where you intend to change the oil, support the tractor with a
suitable support stand and remove the wheel.
•
Rotate the lateral reducer until the drain screw (1) is positioned vertically at the bottom.
•
Place a suitable collection container for used oil under the drain plug at the bottom of the
reducer.
•
Loosen the drain screw and wait until the old oil is drained into the container.
•
After the work is finished, rotate the lateral reducer by 180°; the drain screw is positioned
at the top again.
•
Loosen the control screw (2).
•
Add the prescribed type of oil through the drain opening, with a suitable viscosity that
meets the requirements, refer to the chapter “Technical data of the tractor - oil”.
•
Add oil until it reaches the bottom edge of the control screw opening.
•
Replace the old seal ring on the control screw with a new one and screw it back in its
place.
•
Finally, tighten the drain screws.
WARNING:
Used oil must not be disposed of in the environment. In accordance
with applicable regulations, it must be collected in suitable collection containers.
Summary of Contents for AGT 106
