OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
165
Fig. 190
8.2.3
THE REST FOR THE FINAL WHEEL POSITION
The rest is designed to protect the steering mechanism against sudden loads when the wheel is
turned to the final turning position.
To adjust the rest, follow the procedure below.
•
Activate the parking brake.
•
Place safety wedges to prevent the tractor from moving.
•
Using a hoist, lift the front end of the tractor and make sure its is properly supported with
support stands.
•
Turn the steering wheel to the left and right until reaching the final position of the
steering mechanism.
•
Unscrew the safety nut (1) and adjust the screw (2) to the housing of the sleeve (3).
•
The rest for the final wheel position is adjusted correctly when the distance between the
screw and the housing is not greater than 1 mm.
WARNING:
The rest is only designed for protection and must not come into
contact with the sleeve during normal turning!
Summary of Contents for AGT 106
