Agromehanika AGT 106, Operating Instructions Manual

Page: 70 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
69
Fig. 66
Fig. 67
4.8.3.3 CLUTCH
The clutch is used to control the tractor when driving off and shifting gears. The clutch is
controlled by means of the pedal installed on the left side of the driver's seat.
When the seat is turned, the clutch pedal is pushed upwards; refer to the chapter “Turning the
seat”.
4.8.3.4 ACCELERATOR PEDAL
The accelerator pedal is used to change the
speed of the tractor and to increase or
decrease the number of engine revolutions.
When turning the seat, the accelerator
pedal is pushed upwards; refer to the
chapter “Turning the seat”.
4.8.3.5 ACCELERATOR LEVER
By moving the accelerator lever up and down, the number of engine revolutions can be adjusted
as desired. When the position of the accelerator lever is fixed, the driver can maintain a constant
number of engine revolutions on the tractor.
There is a scale gauge mounted under the lever,
displaying the approximate value of the tractor’s
engine load. The higher the area of the throttle on
the scale, the higher the engine revolutions and the
load on the engine and vice-versa.
If the lever is positioned at a particular point, with
a constant number of revolutions, and then the
number of revolutions is increased by depressing
the accelerator pedal, the number of revolutions
will increase as long as the pedal is depressed.
When the accelerator pedal is released, the number
of engine revolutions drop to the initial position
adjusted with the accelerator pedal.
IMPORTANT: When driving off from a complete stop, release the clutch gently
and slowly apply the throttle to prevent sudden movement!