OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
22
Fig. 24
Fig. 25
Fig. 26
2.11
SAFETY INSTRUCTIONS FOR MAINTENANCE OF THE TRACTOR
In the period of tractor operation, ensure regular maintenance of the tractor in accordance with
time intervals prescribed by the manufacturer. Proper maintenance will ensure a long service life
of the tractor and an appropriate level of safety.
Maintenance work on the tractor can only be performed by authorized service centres complying
with the manufacturer's instructions. Failure to follow this instruction will void your warranty
rights.
Before starting maintenance work on the tractor, shut down the engine,
remove the key and engage the parking brake, then wait for the tractor to
cool down.
•
Learn how to perform the servicing procedures, otherwise leave
this to suitably qualified persons.
•
Keep the workplace clean and dry.
•
Only begin performing maintenance and service procedures when
the tractor is clean.
•
During maintenance and service, disconnect all implements and
remove the weights.
•
Only use appropriate tools and protective equipment when
performing maintenance.
•
Disengage the PTO drive shaft on the tractor to prevent sudden
activation and machine operation (Fig. 25).
•
Before repairs and maintenance, place appropriate supports under
the tractor to prevent uncontrolled movements.
•
Safely support and install all the parts which must be lifted for
servicing.
•
Maintain machine parts in good condition. Any problems should be immediately
repaired. Replace any worn or damaged parts. Remove the excess oil, grease and any
other impurities.
•
Check the condition of the hydraulic system (couplings,
hoses), in particularly hoses leading to the hydraulic
cylinders of the steering system.
•
Check the condition of the air conditioning system and
pay particular attention to the joints.
•
Liquids coming from the hoses may be under high
pressure and can damage your skin. If they penetrate the
skin, they may cause dangerous injuries (Fig. 26).
•
When determining the leakage points on hoses, use a
cardboard for help. Protect your hands and body when handling a circuit under high
pressure.
•
Before repairing high-pressure hoses, always release pressure from the hoses and double-
check that the pressure is released.
•
Before you re-engage the systems under pressure, make sure they are safely connected.
•
In case of injury, seek medical attention. To prevent the risk of serious injuries, block any
penetration of liquids into the skin and remove the liquid within a few hours.
Summary of Contents for AGT 106
