OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
158
Fig. 182
7.11.2
DRIVING THE TRACTOR
To start driving the tractor, follow the instructions for starting described below.
•
Depress the clutch pedal (1) and hold
it down.
•
Start the tractor's engine, refer to the
chapter “Starting the engine”;
•
Select the speed group using the
lever (2).
•
Select the driving direction using the
lever (3).
•
Select a suitable gear using the lever
(4).
•
Release the parking brake.
•
Slowly release the clutch pedal (1),
keep the engine revolutions as low as
possible and carefully depress the
accelerator pedal (6) until the tractor
moves off.
•
When releasing the clutch pedal and
the gearbox is in gear, take care not
to release it suddenly to avoid losing
control over the tractor.
•
After the tractor moves off, you must release the clutch pedal completely, do not hold it
partially depressed; this could result in excessive wear of the clutch disks.
•
To adjust the tractor's driving speed, use appropriate shift levers and the accelerator,
clutch and brake pedals (7).
7.11.3
STOPPING THE TRACTOR
Always stop or park the tractor in areas where it will not obstruct or endanger other road users.
To stop the tractor, follow the instructions described below.
•
Reduce the speed of the tractor by releasing the accelerator pedal.
•
Depress the clutch and brake pedals to stop the tractor.
•
Move the shift levers for driving in neutral position.
•
Deactivate the switch for the rear universal shaft (if used).
•
Pull the parking brake.
•
Lower the implement to the ground (if installed).
•
Shut off the tractor's engine, refer to the chapter “Shutting off the engine”;
•
Move the shift lever to the lowest gear and release the clutch.
•
Remove the key from the ignition lock.
IMPORTANT:
Never hold the clutch pedal depressed for an extended period of
time. In this case, move the lever for changing the driving direction to neutral and
release the clutch pedal.
IMPORTANT:
If the operator leaves the driver’s seat when driving and the
parking brake is not engaged, the tractor starts to beep after 2 seconds. Stop the
tractor in safe conditions and activate the parking brake before leaving the driver’s
seat.
Summary of Contents for AGT 106
