OPERATING INSTRUCTIONS
AGT 1060
Rev.09/2020
143
Fig. 168
7.7.2
DISCONNECTING THE UNIVERSAL JOINT
To disconnect the universal joint from the tractor and the implement (mounted or trailed), follow
the procedure below.
•
Disengage the tractor’s PTO drive shaft, refer to the chapter “PTO drive shaft
disengagement”.
•
Remove the safety chain protecting the safety devices against rotation.
•
Push the safety pin (2) to disconnect the universal joint (1) from the drive shaft on the
tractor and place it in a suitable place to avoid damaging the universal joint.
•
Install the safety guard (3) of the tractor’s PTO drive shaft back in its place.
WARNING:
The tubes of the universal joint must overlap by a minimum of 150
mm!
WARNING: The universal joint must always be disconnected from the
tractor’s PTO drive shaft first before it is disconnected from the PTO drive
shaft on the implement.
Summary of Contents for AGT 106
